- Operating Voltage: 110-120V, 220-240V
- Material : Steel with eproxy finish
- Motor Type: Brush Type, Dual Ball Bearings
- Warm Air Speed Output:79-158mph
- Dryer Shall Deliver: 53.8CFM
- Motor Thermal Protection: Auto Reset @ 105 °C
- Heat Element 200-500 W @ 220 Vac
- Heat Thermal Protection: Auto Reset @ 85 °C
- Dry Time: Less than 15 Seconds
- Stand-by Power: 0.5 W
- Sensor Range: Auto Adjust , Standard 6"
- Circuit Operation: Infrared Automatic, self adjusting
- Time Protection: 60 Seconds Auto Shut Off
- Heat Assembly: 185F
- Sound Level: 75 ± dB-A at 1m
- Drip Proof: IP23
- Isolation: Class 1
- Net Weight: 7.5lbs Shipping Weight: 84.lbs
- Unit Size: 10-55/64 " X 8 1/2" x4"
GENERAL SPECIFICATIONS
| Model |
Heater |
Motor Type |
Air Output |
CFM |
Sound Level |
| 3055 |
250-500W |
Brush Type, Dual Ball Bearing |
55° |
53.80 |
75+/-1 |
ELECTRICAL SPECIFICATIONS
| Model |
Volts |
Amps |
Watts |
HZ |
Drying Level |
| 3055 |
110-120V
|
8.40 |
1000 |
50/60 |
10-15 Sec |
WARRANTY
In addition to Sky's one year guarantee, Sky
extends a limited 5 years warranty from the date of
installation on all parts to the original owner of the
installed unit against defects in factory workmanship or
material under normal use and service. This warranty is
limited to the repair or exchange of defective parts at the
option of SKY.
GENERAL SAFETY INFORMATION
- Disconnect power before installation or servicing.
- This product intended for installation by a
qualified service person. Use AWG No.12 solid conductor
for wiring.
- All units must be supplied with a 3-wire service.
The ground wire must be connected to the dryer's
backplate.
- Failure to properly ground unit could result in
severe electrical shock and / or death.
- Do not install dryer over washbasin.
INSTALLATION
1. Fix the position card on the wall. Suitable height for
hole "D" IS 50" from ground.
2. Drill 4 holes (A.B.C.D. 5/16" diameter and 3/8" depth.)
3. Take off the mounting instruction sheet. Hammer dowel
into 4 holes.
4. Remove the housing fromthe base plate; fix the base
plate firmly on to the wall.
5. Connections:
- Connect the live wire (colored red or brown) to the
terminal block marked "L".
- Connect the natural wire (colored black or blue) to
the terminal blocked marked "N".
- Connect the ground wire (colored green and yellow)
to the green screw marked "".
6. Attach housing back to base plate.
